wind turbine generator

how to make electricity generator for wind turbine from old dc motor new experiment

Electricity Generator For Windmill 

Tips to Make Electricity Generator From Old DC Motor
How to make electricity generator from old DC motor is the need of the hour. The world as we know it today is dependent on electricity for our survival. There are certain ways and some tips to help you in this matter.
Tips to Make Electricity Generator From Old DC Motor
How to make electricity generator from old DC motor is the need of the hour. The world as we know it today is dependent on electricity for our survival. There are certain ways and some tips to help you in this matter.

Old motor that is not in use, whether it is a car battery or a solar power system are the prime candidates for making a motor. This kind of old equipment is inexpensive and if preserved properly can prove to be cost effective too. The basic things that one has to do are assessing the status of your motor and buying the required parts for replacement. One can either take the services of professionals or learn the procedure in a step by step manner. The advantage of learning the procedure of making an old motor at home is that you can save a lot of money by doing this.

Some of the parts that you may need for replacement are brushes, windings, rings and bushings. It is better to buy a complete kit for the assembly of the old motor, if you do not have the required items for the assembly. If you want to assemble the motor in your own, ensure that you have the components that are needed for the entire process and also a good supply of nuts, bolts and washers. Bolts and washers are available in plenty during the sale at hardware stores.

The next step on how to make electricity generator from old DC motor is to remove the old motor. First remove the DC motor that is present in your car battery, the shaft that connects the motor to the battery is the first to be removed. Then remove the wires that are connected with the motor; these should be unplugged and then you should slide off the switch to locate it. Next the belt that is around the DC motor will have to be unbolted, this belt is usually located on the bottom side of the motor.

The next step is to loosen all the bolts that are holding down the flywheel on your DC motor. Remove it carefully to make sure that it does not come off. If you do not know how to make electricity generator from old DC motor, you can ask help from an expert who can guide you properly in removing and reattaching the motor. You need to remove the belt, pulley, and the wheel to access the AC electric motor.

In order to remove the old motor, you need to unplug all the cables and remove the motor from the vehicle. You will find that there are screws that are secured by bolts on the motor housing. You need to remove these screws and remove the motor from the vehicle. After that, you will need to disconnect the electrical connections from the pulley.

As you know that DC motors generate electric power with the help of DC generated in the base and the pole pieces, you need to remove the spindle or the bearing and then disconnect the main cable of the motor. You will find that the cord is wrapped tightly around the pulley. Thus, you will need to make electricity generator from old DC motor by disengaging the pulley.

When you have removed the motor from the old vehicle, you should take some careful steps in order to ensure safety. First, you need to turn off the main power at the circuit. In case, if the circuit is open then you should turn off the generator also. After that, you need to locate the terminal strip near the battery. You should fasten the new DC motor between the terminals and the battery.